Ok I've installed mach 3 made a G-code and imported it ( I've generated it with your post) No circles.

On the megacut2D it generates circles.

Ok Now how to setup Mach3 to run on XMD32 ?

I wil check the nut , how to check this Z driver ? [ Dodano : 2015-07-04, 12:08 ] I think I found the problem ... When I center the tool and on it's highest position it's above 90mm the limit switch diode isn't lightening and probably this is why it's giving those errors. After I center it with spin...

I have an issue with this router. When I load a new operation with a G-code and center the tool Z position ( I check the reading it's 98,5mm table-tool distance) Then after the operation is finished if I continue to load operations all the time the Z position goes down 0.1mm after the operation is f...

Hello , I have recently bought a XMD 32 mill. I am milling molds for carbon blades. Using SolidWorks 2015 and SolidCAM 2015 for design and G-code I have the following issue and don't know the reason ( owners also was unable to iddentity it). So short explanation : When milling 2D surfaces also const...