This is a high cost, function over the entire MACH3 interface board has the following features:
1, fully supports MACH3 and other support parallel control computer software.
2, USB power supply and peripheral phase separation to protect computer security.
3, the external wide input voltage,12 to 24V, and has antireverse function.
4, all input signals all through optical coupling isolation, which can be accessed stop, knife, limit, etc., to
protect computer security.
5, one relay output port, the switch can control the spindle. Output port for the P17 port.
6, all the way through optoisolated 0 to 10V analog voltage output, the inverter can be controlled with a
corresponding analog interface to control the spindle speed. Output port for the P1 port.
7, open to all 17 ports, the drive can be accessed with the optocoupler can be controlled 5axis stepper motor.
8, P1 as PWM outputs can be controlled with optocoupler input shaft governor.
9, can be accessed by common cathode or common anode, the input level for the drive to 5V.
10, all ports printed name plate at a glance
Poza tym sterownik jest opisany z obu stron PCB, Ludzie zacznijcie czytać a potem kupować i kombinować : a na YT to działa a u mnie coś nie . . . !
