Znaleziono 1 wynik

autor: markcomp77
05 maja 2005, 12:45
Forum: TurboCNC
Temat: Ustawienie Enable w TurboCNC v. 4.0
Odpowiedzi: 5
Odsłony: 24326

Re: Ustawienie Enable w TurboCNC v. 4.0

lisow1 pisze:Jak ustawić sygnaŁ Enable w TurboCNC v. 4.0, ? :lol:

[ Dodano: 2005-05-04, 23:09 ]
Chodzi o to że Piny Step i Dir są ustawione i dziaŁają nie dziaŁa tylko Enable:lol:
tajemnica sterowania pewnie jest w konfiguracji:
http://www.dakeng.com/man/turbocnc.html#_Toc90515682
opis_turbocnc pisze:Configure I/O Lines…

There are 40 functions, which can be mapped to parallel port pins if you CNC machine supports the associated features available within TurboCNC. It is not necessary to map all of these functions. Just map the ones that you will use. The available functions are described elsewhere in this manual, and are listed below:
dalej jest tabelka... gdzie określamy "enable"

np. 6 Drive Enable 1 Out

Obrazek
z listy "I/O Pints" wybieramy "enable....xxx"
a pozostałe parametry dla sygnału "enable" - tak coby zadziałało... zgodnie z zadrutowaniem sterownika... itp itd

Wróć do „Ustawienie Enable w TurboCNC v. 4.0”