Znaleziono 1 wynik

autor: ezbig
03 paź 2013, 22:27
Forum: Obróbka drewna
Temat: 6040Z i problemy z wycieciem kwadratu...
Odpowiedzi: 11
Odsłony: 2415

carmamir pisze:Co ciekawe wycinanie profilu wiekszego bez problemow :/

Predkosc 2.5-3.5m/min.
Nie pracowałem już dawno na mach-u, ale o ile dobrze pamiętam, to jest tam w konfiguracji opcja frezowania (z parametrem określającym dokładność), dzięki której silniki nie zwalniają do 0 przy każdym wektorze, tylko jadą z maksymalną prędkością jaka jest możliwa. Normalnie można to włączyć/wyłączyć i ustawić dokładność frezowania jakimś g-kodem (nie pamiętam teraz), ale w mach-u jest to w konfiguracji programu. Opcja ta może powodować przy dużych prędkościach zaokrąglanie rogów przy ostrych zmianach kierunku. Jest to tym bardziej widoczne im mniejsze wycinasz elementy. Tutaj bym szukał problemu.

[ Dodano: 2013-10-04, 00:26 ]
Znalazłem ;)

Z instrukcji do mach-a:
5.6.6 Configure Initial State
Config>State opens a dialog which allows you to define the modes which are active when
Mach3 is loaded (i.e. the initial state of the system). It is shown in figure 5.21.
Motion mode: Constant velocity sets G64, Exact Stop sets G61. For details of these option
see Constant Velocity and Exact Stop in chapter 10.
Trochę więcej:
10.1.16 Path Control Modes

The machining system may be put into any one of two path control modes: (1) exact stop mode, (2) constant velocity mode. In exact stop mode, the machine stops briefly at the end of each programmed move. In constant velocity mode, sharp corners of the path may be rounded slightly so that the feed rate may be kept up. These modes are to allow the user to control the compromise involved in turning corners because a real machine has a finite acceleration due to the inertia of its mechanism.

Exact stop does what it says. The machine will come to rest at each change of direction and the toll will therefore precisely follow the commanded path.

Constant velocity will overlap acceleration in the new direction with deceleration in the current one in order to keep the commanded feedrate. This implies a rounding of any corner but faster and smoother cutting. This is particularly important in routing and plasma cutting. The lower the acceleration of the machine axes, the greater will be the radius of the rounded corner.

Wróć do „6040Z i problemy z wycieciem kwadratu...”